Then install the driver software for your GPIO interface, after that shut down the computer and install the GPIO hardware. How do I load the driver for a GPIB PCMCIA interface? Install the Agilent I/O Libraries. Change the SICL Device Name if needed: lan:lan0 If all settings are correct, load the driver using the 'Load' button.
Just add a new 'HPIBS' driver and open the properties page. The driver for the LAN/GPIB controller can also be laoded through Device Setup.
Adjust this setting according to your configuration. After the interface has been configured use the following command in HTBasic: LOAD BIN 'HPIBS DEV lan:lan0 ISC 7' lan0 is the device name. Make sure that the controller has been configured correctly within the SICL software (Agilent Connection Expert). This documents outlines the most current drivers available for most GPIB hardware when used with Microsoft Windows and DOS.